Background Image
Table of Contents Table of Contents
Previous Page  135 / 182 Next Page
Information
Show Menu
Previous Page 135 / 182 Next Page
Page Background

ROC800-Series Instruction Manual

5-14

Communications

Revised Jul-14

Notes

:

If you are installing a modem module, it is recommended that you

install a surge protector between the RJ-11 jack and the outside line.

The dial-up modem is

not

hot-swappable

or

hot-pluggable. When

installing a dial-up modem module, you

must

remove power from

the ROC800.

5.10 Multi-Variable Sensor (MVS) Interface Module

The Multi-Variable Sensor (MVS) module provides an interface to a

sensor that supplies differential pressure, static pressure, and

temperature inputs to the ROC827 for orifice flow calculation.

The enhanced design of the MVS I/O module (shown on the

right

side

of

Figure 5-6

) enables you to place it in

any

available slot on the

ROC800. In all other ways the two modules are identical.

Figure 5-6. MVS I/O Module

For further technical information about the MVS or MVS I/O modules,

see the description of the MVS I/O module in

Chapter 4

.

5.11 Network Radio Module (NRM)

The Network Radio Module (NRM) is an integral part of the Distributed

RTU Network and allows ROC800-Series (ROC800) to communicate

wirelessly. It has the ability to broadcast and detect information from

other RTUs for easier and faster interconnection and communication

setup.