Background Image
Table of Contents Table of Contents
Previous Page  32 / 182 Next Page
Information
Show Menu
Previous Page 32 / 182 Next Page
Page Background

ROC800-Series Instruction Manual

2-2

Installation and Use

Revised Jul-14

2.1.1 Environmental Requirements

Always install the ROC800 in a user-supplied building or enclosure to

protect it from direct exposure to rain, snow, ice, blowing dust or debris,

and corrosive atmospheres. If you install the ROC800 outside of a

building, it must be placed in a National Electrical Manufacturer’s

Association (NEMA) 3 or higher rated enclosure to ensure the necessary

level of protection.

Note

:

In salt spray environments, it is especially important to ensure

that the enclosure—including all entry and exit points—is sealed

properly.

The ROC800 operates over a wide range of temperatures. However, in

extreme climates it may be necessary to provide temperature-controlling

devices to maintain stable operating conditions. In extremely hot

climates, a filtered ventilation system or air conditioning may be

required. In extremely cold climates, it may be necessary to provide a

thermostatically controlled heater in the same enclosure as the ROC800.

To maintain a non-condensing atmosphere inside the ROC800 enclosure

in areas of high humidity, it may be necessary to add heat or

dehumidification.

2.1.2 Site Requirements

When locating the ROC800 on the site, careful consideration can help

reduce future operational problems. Consider the following items when

choosing a location:

Local, state, and federal codes often place restrictions on locations

and dictate site requirements. Examples of these restrictions are fall

distance from a meter run, distance from pipe flanges, and

hazardous area classifications. Ensure that all code requirements are

met.

Choose a location for the ROC800 to minimize the length of signal

and power wiring.

Locate ROC800s equipped for radio communications so the antenna

has an unobstructed signal path. Antennas should not be aimed into

storage tanks, buildings, or other tall structures. If possible, antennas

should be located at the highest point on the site. Overhead

clearance should be sufficient to allow the antenna to be raised to a

height of at least twenty feet.

To minimize interference with radio communications, choose a

location for the ROC800 away from electrical noise sources, such as

engines, large electric motors, and utility line transformers.

Choose a location for the ROC800 away from heavy traffic areas to

reduce the risk of being damaged by vehicles. However, provide

adequate vehicle access to aid monitoring and maintenance.